High quality adhesive suits all rubber inflatable boats. Including Neoprene/Hypalon and Nitrolon.

Size 800gm/1000ml

Rubber Repair Instructions

To complete the repair you will need –

Adhesive masking tape scissors pencil course sand paper small paint brush mixing pot acetone clean rag hot air gun or hair dryer spoon

1. Cut patch to appropriate size and round off corners. The patch should cover the hole by at least 25mm in every direction
2. Use a pencil to trace the patch on the surface of the boat
3. Tape around the outside of the pencil line using masking tape
4. Roughen all surfaces well with sand paper (You need to take the shine of the boat and the patch material)
5. Clean all surfaces with acetone or MEK
6. Mix the hardener to the adhesive. Apply a thin coat to the boat and the patch
7. Leave the adhesive for 30 minutes and then apply a second coat of adhesive
8. Wait 2-3 minutes until the glue becomes tacky to touch
9. Carefully apply the patch and rub into position with any hard item. (A spoon or spatula is a good option)
10. Remove the masking tape and clean any excess with acetone or MEK

• You should not attempt to repair the boat in direct sunlight or in humid conditions
• For best results leave the boat deflated for 24hrs you could partially inflate the boat after 3 hours in an emergency
• We recommend the boat be inspected professionally if the cut is larger than 60mm or structurally affected

 Instructions also provided on the adhesive tin.

Note: All website prices exclude freight and handling. To calculate the amount please click ADD TO CART and enter your postcode.